3D Printed Duct Tape Clip-On Tie Project

This video was harder than most… to film. For some reason I just could not find the time. Life is still a bit up-in-the-air at the moment, which can make finding time to set up the camera a challenge. but I managed to film, edit, and upload this video. It’s an editing heavy one, too.

I made 2 versions of this. One specifically for social media that lacks the commentary at the end, and this one. I should really get on more social media outlets.

When trying to decide what music to put in the background for this one, I realized I could use the same piece I use for the intro, Marty Gots a Plan, but extend it so you hear more than the 3 second clip I normally use. I think it worked rather well and it was pleasing to hear the song in it’s entirety, more or less. My only regret is that I didn’t think to get a clean recording of the duct tape unrolling and overlay it on the audio. That’s just such a satisfying sound.

Riiiiiiiiiiiiiiiiiich.

Download link: https://pinshape.com/items/21703-3d-printed-3d-printed-clip-on-duct-tape-neck-tie