I went back in this video to recording the audio on my computer and the video on my camera, the syncing them up in post. This requires an additional effort on my part, but until I get the audio sync issues on my streaming setup, which you can see in last night twitch stream is going bonkers, worked out I’m going to have to do it this way.
I’m abusing this printer pretty solidly. Mostly my abuse is confined to the build tak. Still, I don’t think I deserved this:
Near the tail end of a 20 hour print I go to bed because things are looking good and I wake up to this mess.
The filament is broken as well, and I don’t know if that has anything to do with it, but I’m apparently going to spend some time at wanhao3dprinter.com to figure out how to get this pritning again, because it absolutely refuses to work right now. So maybe I was a bit generous with my review, which was already struggling to find things to praise this machine about. (I may be a bit bitter this morning.)
