I managed to get my build plate level enough through trial and error, but I noticed when I was printing large batches of TARDIS rings that it wasn’t quite right. On the advice of Andrew Morrow I decided to buy the parts to build a leveling jig. Then I noticed there was a version that just snaps on to the print head carriage. Well that’s even better!
 |
| only good for the front half |
Only it’s not better. It sits so far forward that you can only tell if the front half of your bed is level. Better make sure when you buy your digital indicator to buy a pack of magnets too and just make the good one.
 |
| the good one |
I didn’t buy the magnets so I just had to hold it on. It still leveled my print bed real good. I’ll stop by harbor freights to get the magnets, hopefully, before I need to level again.
